Free Domestic Shipping!
Earthquake Sound's PA-600 can be used in Stereo Mode as two separate power amplifiers, each capable of driving loads down to 2-ohms. Each channel operates independently and has its own input connectors, sensitivity level controls, signal indicator LEDS, limiter circuitry, fault protection circuitry, power amp, and speaker outputs.

Special Features
Features
Input Connections:
XLR, RCA, and 1/4" phone (tip/ring/sleeve), one per channel
Output Connections:
Binding posts & phone jacks
Cooling:
Variable speed forced air fan cooling rear/side intake, front exhaust
Mode Switches:
Mono bridge mode select & Limiter "on/off" switch
Protection Circuitry:
Short circuit, open circuit, RF burnout, over temp, speaker protection relays, turn on/off transient protection, DC protection and limiter circuitry.

PA-600
Frequency Response +/- 0.5dB, 20Hz to 20kHz
Power Per Channel
(8-ohm Stereo) 2 x 120 watts RMS @ 8-ohms (Stereo Mode)
Power Per Channel
(4-ohm Stereo) 2 x 200 watts RMS @ 4-ohms (Stereo Mode)
Power Per Channel
(2-ohm Stereo) 2 x 300 watts RMS @ 2-ohms (Stereo Mode)
Power Per Channel
(8-ohm Mono) 380 watts RMS @ 8-ohms (Mono Mode)
Power Per Channel
(4-ohm Mono) 560 watts RMS @ 4-ohms (Mono Mode)
Signal to Noise Ration >98dB ref 200 watts / 4-ohms (20kHz equivalent bandwidth)
Input Impedance 2-ohms or greater in stereo mode / 4-ohms or greater in mono mode
Channel Separation 100dB
Input Voltage (max) 1.5 Volts
Total Harmonic Distortion <0.05%, 20Hz to 20kHz
Damping Factor Typical 300 (1kHz, 8-ohms)
Power Requirements 110 VAC 60Hz, 750VA
100-120 VAC 50/60Hz, 750VA
220-240 VAC 50/60Hz, 750VA
Dimension 3 1/2" x 19" x 15 7/16" (HxWxD)
88.8mm x 482.6mm x 392mm
Weight 29 lbs.
Finish Black Finish